Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1181)

Brocade Mobility RFS Controller CLI Reference Guide 1173
53-1003098-01
Chapter
22
WLAN-QOS-POLICY
This chapter summarizes the WLAN QoS policy in the CLI command structure.
A WLAN QoS policy increases network efficiency by prioritizing data traffic. Prioritization reduces
congestion. This is essential because of the lack of bandwidth for all users and applications. QoS
helps ensure each WLAN on the wireless controller receives a fair share of the overall bandwidth,
either equally or as per the proportion configured. Packets directed towards clients are classified
into categories such as Video, Voice and Data. Packets within each category are processed based
on the weights defined for each WLAN
Each WLAN QoS policy has a set of parameters which it groups into categories, such as
management, voice and data. Packets within each category are processed based on the weights
defined for each WLAN.
Use the (config) instance to configure WLAN QoS policy commands. To navigate to the WLAN QoS
policy instance, use the following commands:
(config)#wlan-qos-policy
rfs7000-37FABE(config)#wlan-qos-policy test
rfs7000-37FABE(config-wlan-qos-test)#?
WLAN QoS Mode commands:
accelerated-multicast Configure accelerated multicast streams address and
forwarding QoS classification
classification Select how traffic on this WLAN must be classified
(relative prioritization on the radio)
multicast-mask Egress multicast mask (frames that match bypass the
PSPqueue. This permits intercom mode operation
without delay even in the presence of PSP clients)
no Negate a command or set its defaults
qos Quality of service
rate-limit Configure traffic rate-limiting parameters on a
per-wlan/per-client basis
svp-prioritization Enable spectralink voice protocol support on this wlan
voice-prioritization Prioritize voice client over other client (for
non-WMM clients)
wmm Configure 802.11e/Wireless MultiMedia parameters
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-wlan-qos-test)#