Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 714)

Brocade Mobility RFS Controller CLI Reference Guide 701
53-1003098-01
7
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
description Primary\ radio\ to\ use
channel 1
data-rates b-only
beacon period 50
beacon dtim-period bss 1 5
beacon dtim-period bss 2 2
beacon dtim-period bss 3 5
beacon dtim-period bss 4 5
beacon dtim-period bss 5 5
beacon dtim-period bss 6 5
beacon dtim-period bss 7 5
beacon dtim-period bss 8 5
beacon dtim-period bss 9 5
beacon dtim-period bss 10 5
beacon dtim-period bss 11 5
beacon dtim-period bss 12 5
beacon dtim-period bss 13 5
beacon dtim-period bss 14 5
beacon dtim-period bss 15 5
beacon dtim-period bss 16 5
antenna-gain 12.0
aggregation ampdu tx-only
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
dfs-rehome
interface-config-radio-instance
Reverts to configured home channel once the Dynamic Frequency Selection (DFS) evacuation
period expires
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
dfs-rehome
Parameters
None
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#dfs-rehome
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
no Removes a radio’s description
no Stays on DFS elected channel after evacuation period expires