Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1214)

1206 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
23
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
[establishment-criteria|hostname|local-ip-address|mtu|peer|router-id|session|
use]
Parameters
no
[establishment-criteria|hostname|local-ip-address|mtu|peer|router-id|session|
use]
Example
The tunnel settings before the ‘no’ command is executed:
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#show
context
l2tpv3 tunnel Tunnel1
local-ip-address 172.16.10.2
mtu 1280
hostname TunnelHost1
establishment-criteria cluster-master
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
The tunnel settings after the ‘no’ command is executed:
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#no
local-ip
-address
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#no mtu
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#no
hostname
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#show
context
l2tpv3 tunnel Tunnel1
establishment-criteria cluster-master
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
establishment-criteria Resets the tunnel’s establishment criteria to default
no hostname Removes the tunnel’s local hostname
no local-ip-address Resets the tunnel’s local IP address and re-establishes the tunnel
no mtu Resets the MTU size for this tunnel to default (1460 bytes)
no peer Removes the peer configured for this tunnel
no router-id Removes the tunnel’s router ID
no session Removes a session
no use Removes the L2TPv3 policy associated with a tunnel and reverts to the default tunnel policy