Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1146)

1138 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
20
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
[area|assignable-power|channel-list|channel-width|coverage-hole-recovery|enab
le|
group-by|interference-recovery|neighbor-recovery|smart-ocs-monitoring]
Parameters
no
[area|assignable-power|channel-list|channel-width|coverage-hole-recovery|enab
le|
group-by|interference-recovery|neighbor-recovery|smart-ocs-monitoring]
Example
The following example shows the Smart RF policy ‘test’ settings before the
‘no’ commands are executed:
rfs7000-37FABE(config-smart-rf-policy-test)#show context
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
group-by floor
sensitivity custom
assignable-power 5GHz min 8
assignable-power 5GHz max 20
channel-list 2.4GHz 1,12
channel-width 5GHz auto
interference-recovery channel-switch-delta 5GHz 5
neighbor-recovery power-threshold 5GHz -65
neighbor-recovery power-threshold 2.4GHz -82
coverage-hole-recovery snr-threshold 5GHz 1
rfs7000-37FABE(config-smart-rf-policy-test)#
rfs7000-37FABE(config-smart-rf-policy-test)#no interference-recovery
channel-switch-delta 5GHz
rfs7000-37FABE(config-smart-rf-policy-test)#no neighbor-recovery
power-threshold 2.4GHz
no area Removes channel list/ power configuration for an area
no assignable-power Resets assignable power to its default
no auto-assign-sensor Disables auto assignment of sensor radios to its default
no channel-list Resets the channel list for the selected frequency to its default
no channel-width Resets channel width for the selected frequency to its default
no coverage-hole-recovery Disables recovery from coverage hole errors
no enable Disables a Smart RF policy
no group-by Removes a Smart RF policy’s group settings
no interference-recovery Disables recovery from errors due to excessive noise and interference
no neighbor-recovery Disables recovery from errors due to faulty neighbor radios
no smart-ocs-monitoring Disables off channel monitoring
When used on an AP7161 model access point, this command disables a meshpoint.