Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 270)

254 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
Syntax:
mac access-list
Parameters
mac access-list
Example
rfs7000-37FABE(config)#mac access-list test
rfs7000-37FABE(config-mac-acl-test)#?
MAC Extended ACL Configuration commands:
deny Specify packets to reject
disable Disable rule if not needed
no Negate a command or set its defaults
permit Specify packets to forward
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-mac-acl-test)#
Related Commands:
NOTE
For more information on Access Control Lists, see Chapter 12, ACCESS-LIST .
management-policy
Global Configuration Commands
Configures a management policy. Management policies include services that run on a device,
welcome messages, banners etc.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
access-list
Configures a MAC access control list
•
– Specify the ACL name. If the access control list does not exist, it is
created.
no Removes a MAC access control list