Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 783)

770 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Usage Guidelines:
For Vehicular Mounted Modem (VMM) access points or other mobile devices, set the path selection
method as mobile-snr-leaf in the config-meshpoint-device mode. For more information, see
path-method .
Example
rfs7000-37FABE(config-profile-testBrocade Mobility 71XX Access
Point)#meshpoint-device test
rfs7000-37FABE(config-profile-testBrocade Mobility 71XX Access
Point-meshpoint-test)#
rfs7000-37FABE(config-profile-testBrocade Mobility 71XX Access
Point-meshpoint-test)#?
Mesh Point Device Mode commands:
acs Configure auto channel selection parameters
exclude Exclude neighboring Mesh Devices
hysteresis Configure path selection SNR hysteresis values
monitor Event Monitoring
no Negate a command or set its defaults
path-method Path selection method used to find a root node
preferred Configure preferred path parameters
root Set this meshpoint as root
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-testBrocade Mobility 71XX Access
Point-meshpoint-test)#
Related Commands:
NOTE
For more information on the meshpoint-device configuration parameters, see Chapter 27,
<$elemtextMESHPOINT.
meshpoint-monitor-interval
Profile Config Commands
Configures the meshpoint monitoring interval. This is the interval, in seconds, the up/down status
of a meshpoint is checked.
Supported in the following platforms:
no Removes a specified meshpoint