Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 265)

Brocade Mobility RFS Controller CLI Reference Guide 249
53-1003098-01
4
ip access-list BROADCAST-MULTICAST-CONTROL
.............................................................................
global-association-list my-clients
permit 00-23-69-11-E6-C4 description "10th floor Lab1 Workstation1"
!
global-association-list test
permit 11-22-33-44-55-66 description test
deny 22-33-44-55-66-77 description "Test Deny"
!
captive-portal test
--More--
rfs4000-229D58(config)#
rfs4000-229D58(config-device-00-23-68-22-9D-58)#use global-assoc-list server
my-
clients
rfs4000-229D58(config-device-00-23-68-22-9D-58)#
rfs4000-229D58(config-device-00-23-68-22-9D-58)#show context
rfs4000 00-23-68-22-9D-58
use profile default-rfs4000
use rf-domain default
hostname rfs4000-229D58
license AP DEFAULT-6AP-LICENSE
license ADSEC DEFAULT-ADV-SEC-LICENSE
ip default-gateway 192.168.13.2
ip default-gateway priority static-route 20
interface ge1
switchport mode access
switchport access vlan 1
interface vlan1
ip address 192.168.13.9/24
ip address 192.168.0.1/24 secondary
ip dhcp client request options all
use global-association-list server my-clients
use client-identity-group ClientIdentityGroup
logging on
logging console warnings
logging buffered warnings
rfs4000-229D58(config-device-00-23-68-22-9D-58)#
host
Global Configuration Commands
Enters the configuration context of a remote device using its hostname
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax: