Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 943)

932 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
13
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
dhcp-class
Parameters
dhcp-class
Example
rfs7000-37FABE(config-dhcp-policy-test)#dhcp-class dhcpclass1
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#?
DHCP class Mode commands:
multiple-user-class Enable multiple user class option
no Negate a command or set its defaults
option Configure DHCP Server options
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#
Related Commands:
dhcp-class-mode commands
dhcp-class
Use DHCP class mode commands to configure the parameters of the DHCP user class.
Creates a DHCP user class
•
– Specify a name that appropriately identifies this class of wireless clients. If
the class does not exist, it is created. The class name should not exceed 32 characters in length.
no Removes a configured DHCP user class policy