Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1328)

1320 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
28
nai-realm mai.testrealm.com
net-auth-type accept-terms url www.motorolasolutions.com
3gpp mcc 505 mnc 14
rfs4000-229D58(config-passpoint-policy-test)#
operator
passpoint-policy
Configures the operator friendly name for this hotspot. The name can be configured in English or in
any language other than English. When the name is specified in English, the system allows an ASCII
input. If you are using a language other than English, first specify the ISO-639 language code, and
then specify the name as an hexadecimal code.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
operator name [|iso-lang ]
operator name
operator name iso-lang
Parameters
operator name
operator name iso-lang
Example
rfs4000-229D58(config-passpoint-policy-test)#operator name emergencyservices
rfs4000-229D58(config-passpoint-policy-test)#
rfs4000-229D58(config-passpoint-policy-test)#show context
hotspot2-policy test
connection-capability ip-protocol 2 port 10 closed
domain-name TechPubs
no internet
ip-address-type ipv6 available
nai-realm mai.testrealm.com
net-auth-type accept-terms url www.motorolasolutions.com
operator name emergencyservices
name Configures the operator’s name in English
•
– Specify the operator friendly name in ASCII format.
name iso-lang
Configures a non-English operator’s name
•
iso-lang – Identifies the language by its ISO 639 language code (for example,
‘chi-chinese’ or ‘spa-spanish’).
•
– Specify the 3 character iso-639 language code (for example,
‘chi-chinese’ or ‘spa-spanish
•
– Specifies the operator’s name as a hexadecimal code