Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 161)

144 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
exit
Privileged Exec Mode Commands
Ends the current CLI session and closes the session window
For more information, see exit .
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
exit
Parameters
None
Example
rfs7000-37FABE#exit
virtual-machine
Privileged Exec Mode Commands
Installs, configures, and monitors the status of third-party virtual machines (VMs)
In addition to the Brocade shipped VMs, Brocade Mobility RFS9510 series service platforms
support the installation and administration of third-party VMs. However, the third-party VMs
supported by these devices varies.
The third-party VMs supported on the Brocade Mobility RFS9510 are:
• ADSP
• TEAM-CMT
Use the virtual-machine command to install the third-party VMs, and configure parameters, such
as install media type and location, number of Virtual Central Processing Units (VCPUS), VM
memory, VM disk, number of Virtual Network Interfaces (VIFs), and Virtual Networking Computing
(VNC) port.
Installing third-party VMs saves on hardware cost and provides a unified VM management
interface.
This section is organized into the following sub-sections:
• Syntax Brocade Mobility RFS9510
Supported in the following platforms:
• Service Platforms — Brocade Mobility RFS9510