Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1022)

Brocade Mobility RFS Controller CLI Reference Guide 1013
53-1003098-01
15
udp port <2-65534>
Example
rfs7000-37FABE(config-mint-policy-global-default)#udp port 1024
rfs7000-37FABE(config-mint-policy-global-default)#show context
mint-policy global-default
udp port 1024
mtu 996
level 2 area-id 2000
sign-unknown-device
security-level control-and-data
rejoin-timeout 1000
rfs7000-37FABE(config-mint-policy-global-default)#
Related Commands:
no
mint-policy
Negates a command or reverts values to their default. When used in the config MiNT policy mode,
the
no
command resets or reverts the following global MiNT policy parameters: routing level, MTU,
router packet priority, and UDP or IP encapsulation settings.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [level|mtu|router|udp]
no level 2 area-id
no mtu
no router packet priority
no udp port
Parameters
port <2-65534> Configures default UDP port used for MiNT control packet encapsulation
•
<2-65534> – Enter a value from 2 - 65534. This value specifies an alternate UDP port used by MiNT
control packets and must be an even number. The specified port number plus 1 is used to carry
MiNT data packets. The default value is 24576.
no Reverts MiNT UDP/IP encapsulation to its default