Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 623
610
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
write Write running configuration to memory or terminal
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#1)#
To navigate to the remote VPN client configuration instance, use the following command:
In the device-config mode:
ipsec-isakmp
{dynamic}
In the profile-config mode:
ipsec-isakmp {dynamic}
rfs4000-229D58(config-device-00-23-68-22-9D-58)#crypto map test 2 ipsec-isakmp
dynamic
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#?
Dynamic Crypto Map Configuration commands:
local-endpoint-ip Use this IP as local tunnel endpoint address, instead
of the interface IP (Advanced Configuration)
modeconfig Set the mode config method
no Negate a command or set its defaults
peer Add a remote peer
pfs Specify Perfect Forward Secrecy
remote-type Set the remote VPN client type
security-association Security association parameters
transform-set Specify IPSec transform to use
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#
The following table lists the IPSec-Auto-VPN/Remote-VPN tunnel configuration commands:
Command
Description
Reference
Enables this setting to utilize IP/Port NAT on the VPN tunnel. This command is applicable only
to the site-to-site VPN tunnel.
Uses the configured IP as local tunnel endpoint address, instead of the interface IP. This
command is applicable to the site-to-site VPN tunnel and remote VPN client.
Configures the mode config method (pull or push) associated with the remote VPN client. This
command is applicable only to the remote VPN client.
Configures the IKEv1 or IKEv2 peer for the VPN tunnel. This command is applicable to the
site-to-site VPN tunnel and remote VPN client.
Configures the Perfect Forward Secrecy (PFS) for the VPN tunnel. This command is applicable
to the site-to-site VPN tunnel and remote VPN client.