Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 149)

132 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
page
Parameters
None
Example
rfs7000-37FABE#page
rfs7000-37FABE#
Related Commands:
ping
Privileged Exec Mode Commands
Sends Internet Controller Message Protocol (ICMP) echo messages to a user-specified location
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
ping {count <1-10000>|dont-fragment {count|size}|size <1-64000>}
Parameters
ping {count <1-10000>|dont-fragment {count|size}|size <1-64000>}
no Disables controller paging
Specify the destination IP address or hostname to ping. When entered without any parameters, this
command prompts for an IP address or a hostname.
count <1-10000> Optional. Sets the pings to the specified destination
•
<1-10000> – Specify a value from 1 - 10000. The default is 5.