Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 505)

Brocade Mobility RFS Controller CLI Reference Guide 491
53-1003098-01
6
show mint lsp
show mint lsp-db {details } {(on )}
show mint mlcp {history} {(on )}
Example
rfs7000-37FABE(config)#show mint stats
0 L1 neighbors
L1 LSP DB size 1 LSPs (0 KB)
1 L1 routes
Last SPFs took 0s
SPF (re)calculated 1 times.
levels 1
base priority 180
dis priority 180
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show mint lsp
id 70.37.fa.be, level 1, seqnum 18640, 0 adjacencies, 0 extended-vlans,
expires in 1145 seconds, republish in 722 seconds, changed True,
ext-vlan FDB pri 0, 180 bytes
rfs7000-37FABE(config)#show mint lsp-db
1 LSPs in LSP-db of 70.37.FA.BE:
LSP 70.37.FA.BE at level 1, hostname "rfs7000-37FABE", 0 adjacencies, seqnum
84941
rfs7000-37FABE(config)#
tunnel-controller Displays details of MiNT VLAN network tunnel wireless controllers for extended VLAN load balancing
details
{(on )} The following keywords are common to the ‘dis’, ‘links’, ‘neighbors’, and ‘tunnel-controller’ parameters:
•
details – Optional. Displays detailed MiNT information
•
on – Optional. This is a recursive parameter, which displays MiNT
information on a specified device
mint Displays MiNT protocol information based on the parameters passed
lsp Displays this router's MiNT Label Switched Paths (LSPs)
mint Displays MiNT protocol information based on the parameters passed
lsp-db Displays MiNT LSP database entries
details Optional. Displays detailed MiNT LSP database entries
•
– Specify the MiNT address in the AA.BB.CC.DD format.
on The following keyword is recursive and common to the ‘details’ parameter:
•
on – Optional. Displays MiNT LSP database entries on a
specified device
•
– Specify the name of the AP or wireless controller
mint Displays MiNT protocol information based on the parameters passed
mlcp Displays MiNT Link Creation Protocol (MLCP) status
history Optional. Displays MLCP client history
•
on – Optional. Displays MLCP client history on a specified device
on The following keyword is recursive and common to the ‘history’ parameter:
•
on – Optional. Displays MLCP client history on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.