Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 79)

Brocade Mobility RFS Controller CLI Reference Guide 61
53-1003098-01
2
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
ssh
Parameters
ssh
Example
rfs7000-37FABE>ssh 172.16.10.4 admin
The authenticity of host '172.16.10.4 (172.16.10.4)' can't be established.
RSA key fingerprint is 82:b7:27:86:de:08:e8:53:9f:d6:a3:88:aa:1f:e8:ff.
Are you sure you want to continue connecting (yes/no)?
telnet
User Exec Commands
Opens a Telnet session between two network devices
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
telnet {}
Parameters
telnet {}
Example
rfs4000-229D58>telnet 192.168.13.9
Entering character mode
Escape character is '^]'.
[] Specify the IP address or hostname of the remote system.
Specify the name of the user requesting SSH connection with the remote system.
Configures the destination remote system’s IP address or hostname. The Telnet session is established
between the connecting system and the remote system.
•
– Specify the remote system’s IP address or hostname.
Optional. Specify the Transmission Control Protocol (TCP) port number.