Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1171)

Brocade Mobility RFS Controller CLI Reference Guide 1163
53-1003098-01
21
frame-type
[all|assoc|auth|beacon|data|deauth|disassoc|mgmt|probe-req|probe-resp|
reassoc]
Parameters
frame-type
[all|assoc|auth|beacon|data|deauth|disassoc|mgmt|probe-req|probe-resp|
reassoc]
Usage Guidelines:
The frame type configured determines the SSID match type configured. To configure the SSID
match type as SSID, the frame type must be beacon, probe-req or probe-resp.
Example
rfs7000-37FABE(config-test-signature-test)#frame-type reassoc
rfs7000-37FABE(config-test-signature-test)#show context
signature test
bssid 11-22-33-44-55-66
dst-mac 55-66-77-88-99-00
frame-type reassoc
filter-ageout 8
rfs7000-37FABE(config-test-signature-test)#
Related Commands:
interference-event
signature mode commands
Configures this WIPS policy signature as Smart RF interference source
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
frame-type Configures the frame type used for matching
all Configures all frame type matching
assoc Configures association frame matching
auth Configures authentication frame matching
beacon Configures beacon frame matching
data Configures data frame matching
deauth Configures deauthentication frame matching
disassoc Configures disassociation frame matching
mgmt Configures management frame matching
probe-req Configures probe request frame matching
probe-resp Configures probe response frame matching
reassoc Configures re-association frame matching
no Resets a WIPS signature frame type