Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 232)

216 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
clone TLO
clone device
Example
rfs7000-37FABE(config)#clone rf_domain RF_Domain_Cloned RF_Domain_New
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show context
!
! Configuration of Brocade Mobility RFS7000 version 5.5.0.0-018D
!
!
version 2.1
customize show-wireless-client mac ip vendor vlan radio-id state wlan location
radio-alias radio-type
.............................................................................
........
!
rf-domain RF_Domain_New
location
contact
timezone
country-code
--More--
rfs7000-37FABE(config)#
customize
Global Configuration Commands
Customizes the output of the summary CLI commands. Use this command to define the data
displayed as a result of various show commands.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
TLO
> Creates a new TLO by cloning an existing top-level object. The new object has the same configuration as the
cloned object.
•
– Specify the existing object’s (to be cloned) name
•
– Provide the new object’s name.
NOTE: Enter clone and press Tab to list objects available for cloning.
device
NAME>
Configures a new device based on an existing device configuration
•
– Specify the existing device’s name or MAC address (the device to be
cloned)
•
– Provide the new device’s MAC address.
NOTE: Enter clone > device and press Tab to list devices available for cloning.