Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 231)

Brocade Mobility RFS Controller CLI Reference Guide 215
53-1003098-01
4
Syntax:
no client-identity
Parameters
no client-identity
Example
rfs4000-229D58(config-client-identity-group-test)#show context
client-identity-group test
client-identity test precedence 1
rfs4000-229D58(config-client-identity-group-test)#
rfs4000-229D58(config-client-identity-group-test)#no client-identity test
rfs4000-229D58(config)#
Related Commands:
clone
Global Configuration Commands
Creates a replica of an existing object or device. The configuration of the new object or device is an
exact copy of the existing object or device configuration. Use this command to copy existing
configurations and then modifying only the required parameters.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
clone [TLO|device]
clone TLO
clone device
Parameters
no client-identity
Disassociates a specified client identity from this client identity group
•
– Specify the client identity name.
client-identity Associates an existing and configured client identity (device fingerprinting) with this client identity group