Br-detection – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1155
Brocade Mobility RFS Controller CLI Reference Guide
1147
53-1003098-01
21
br-detection
Enables the detection of unauthorized or unsanctioned APs. Unauthorized APs are untrusted
access points connected to an access point managed network. These untrusted APs accept
wireless client associations. It is important to detect such rogue APs and declare them
unauthorized.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
br-detection {ageout|wait-time}
br-detection {age-out <30-86400>|wait-time <10-600>}
Parameters
Configures events
Configures the duration event duplicates are omitted from the event history
Specifies events contributing to the Smart RF WiFi interference calculations
Negates a command or sets its default
Configures a WIPS policy signature and enters its configuration mode
Defines a WIPS policy settings
Clears the display screen
Commits (saves) changes made in the current session
Ends and exits the current mode and moves to the PRIV EXEC mode
Ends the current mode and moves to the previous mode
Displays the interactive help system
Reverts changes to their last saved configuration
Invokes service commands to troubleshoot or debug
(config-if)
instance
configurations
Displays running system information
Writes information to memory or terminal
TABLE 19
WIPS-Policy-Config Commands
Command
Description
Reference