Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 992)

982 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
14
alg [dns|facetime|ftp|sccp|sip|tftp]
Parameters
alg [dns|facetime|ftp|sccp|sip|tftp]
Example
rfs7000-37FABE(config-fw-policy-test)#alg tftp
Related Commands:
clamp
firewall-policy
This option limits the TCP Maximum Segment Size (MSS) to the size of the Maximum Transmission
Unit (MTU) discovered by path MTU discovery for the inner protocol. This ensures the packet
traverses through the inner protocol without fragmentation.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
clamp tcp-mss
Parameters
clamp tcp-mss
Example
rfs7000-37FABE(config-fw-policy-test)#clamp tcp-mss
alg Enables preconfigured algorithms. The default is enabled.
dns Enables the Domain Name System (DNS) algorithm. The default is enabled.
facetime Enables the FaceTime algorithm. The default is enabled.
ftp Enables the File Transfer Protocol (FTP) algorithm. The default is enabled.
sccp Enables the Skinny Call Control Protocol (SCCP) algorithm. The default is enabled.
sip Enables the Session Initiation Protocol (SIP) algorithm. The default is enabled.
tftp Enables the Trivial File Transfer Protocol (TFTP) algorithm. The default is enabled.
no Disables or resets a specified algorithm
tcp-mss Limits the TCP MSS size to the MTU value of the inner protocol for tunneled packets