Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 191)

Brocade Mobility RFS Controller CLI Reference Guide 175
53-1003098-01
4
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-assoc-acl-test)#
Related Commands:
NOTE
For more information on the association-acl-policy, see Chapter 11, ASSOCIATION-ACL-POLICY .
auto-provisioning-policy
Global Configuration Commands
Configures an auto provisioning policy. This policy configures the automatic provisioning of device
adoption. The policy configures how an AP is adopted based on its type.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
auto-provisioning-policy
Parameters
auto-provisioning-policy
Example
rfs7000-37FABE(config)#auto-provisioning-policy test
rfs7000-37FABE(config-auto-provisioning-policy-test)#?
Auto-Provisioning Policy Mode commands:
adopt Add rule for device adoption
default-adoption Adopt devices even when no matching rules are found.
Assign default profile and default rf-domain
deny Add rule to deny device adoption
no Negate a command or set its defaults
redirect Add rule to redirect device adoption
upgrade Add rule for device upgrade
no Resets values or disables commands
Y-NAME> Specify the auto provisioning policy name. If the policy does not exist, it is created.