Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 365)

Brocade Mobility RFS Controller CLI Reference Guide 349
53-1003098-01
4
client-load-balancing band-discovery-intvl 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
broadcast-dhcp validate-offer
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
proxy-arp-mode
wlan-mode commands
Enables proxy ARP mode for handling ARP requests
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
proxy-arp-mode [dynamic|strict]
Parameters
proxy-arp-mode [dynamic|strict]
Example
rfs7000-37FABE(config-wlan-test)#proxy-arp-mode strict
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid test
bridging-mode local
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
proxy-arp-mode strict
broadcast-dhcp validate-offer
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
radio-resource-measurement
wlan-mode commands
Enables support for 802.11k radio resource measurement
Supported in the following platforms:
proxy-arp-mode Enables proxy ARP mode for handling ARP requests. The options available are dynamic and strict.
dynamic Forwards ARP requests to the wireless side (for which a response could not be proxied)
strict Does not forward ARP requests to the wireless side