Allowed-vlans – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1275
Brocade Mobility RFS Controller CLI Reference Guide
1267
53-1003098-01
27
allowed-vlans
Defines VLANs allowed on the mesh network. A VLAN must be added to the allowed VLANs list for
data to be allowed across the mesh network. Use this command to remove VLANs from the list of
allowed VLANs.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
allowed-vlans [
Parameters
allowed-vlans [
Example
rfs7000-37FABE(config-meshpoint-test)#allowed-vlans 1
rfs7000-37FABE(config-meshpoint-test)#allowed-vlans add 10-23
rfs7000-37FABE(config-meshpoint-test)#allowed-vlans remove 17
Ends the current mode and moves to the previous mode
Displays the interactive help system
Reverts changes to their last saved configuration
Invokes service commands to troubleshoot or debug
(config-if)
instance
configurations
Displays running system information
Writes information to memory or terminal
TABLE 25
Meshpoint-Config commands
Command
Description
Reference
allowed-vlans
Defines VLANs allowed access on the mesh network
The VLAN ID or the range of IDs to be managed.
A single VLAN or multiple VLANs can be added to the list of allowed VLANs. When adding multiple VLANs,
specify the range (for example, 10-20, 25, 30-35). Use this command to create a VLAN list on a new
meshpoint.
add
Adds a single VLAN or a range of VLANs to the list of allowed VLANs. To specify a range of VLANs, specify the
first and last VLAN ID in the range separated by a hyphen (for example, 1-10).
remove
Removes a single VLAN or a range of VLANs from the list of allowed VLANs.