Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 821)

808 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
adoption-site
Device Config Commands
Sets the device’s adoption site name
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
preferred-tunnel-control
ler Configures the tunnel wireless controller or service platform preferred by the system for
tunneling extended VLAN traffic page 785
radius Configures device-level RADIUS authentication parameters page 7-786
remove-override Removes device overrides page 7-824
rf-domain-manager Enables the RF Domain manager page 7-787
router Configures dynamic router protocol settings. page 788
rsa-key Assigns a RSA key to SSH page 7-826
sensor-server Configures an AirDefense sensor server page 7-827
spanning-tree Enables spanning tree commands page 7-789
timezone Configures wireless controller or service platform’s time zone settings page 7-828
trustpoint Assigns a trustpoint to a service page 7-829
tunnel-controller Configures the tunneled WLAN (extended VLAN) wireless controller or service platform’s
name page 791
use Defines the settings used with this command page 7-792
vrrp Configures VRRP group settings page 795
wep-shared-key-auth Enables support for 802.11 WEP shared key authentication page 7-798
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug (config-if) instance
configurations
page 799
show Displays running system information page 429
write Writes information to memory or terminal page 425
Command Description Reference