Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 209)

Brocade Mobility RFS Controller CLI Reference Guide 193
53-1003098-01
4
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
server [host|mode]
server host
server mode [centralized|centralized-controller {hosting-vlan-interface
<0-4096>}|
self]
Parameters
server host
server mode [centralized|centralized-controller {hosting-vlan-interface
<0-4096>}|
self]
Example
rfs7000-37FABE(config-captive-portal-test)#server host 172.16.10.9
rfs7000-37FABE(config-captive-portal-test)#show context
captive-portal test
access-time 35
custom-auth info bob,\ [email protected]
connection-mode https
inactivity-timeout 750
server host 172.16.10.9
rfs7000-37FABE(config-captive-portal-test)#
Related Commands:
host Configures the internal captive portal authentication server (wireless controller, access point, service
platform)
•
– Specify the IP address or hostname of the captive portal server.
NOTE: For centralized wireless controller mode, this should be a virtual hostname and not IP address.
mode Configures the captive portal server mode
centralized Considers the configured server’s hostname or IP address as the centralized captive portal server. Select
this option if the captive portal is supported on an external server.
centralized-controller
{hosting-vlan-interface
<0-4096>} Configures the numeric IP address (or DNS hostname) for the server validating guest user permissions for
the captive portal policy. This option is available only for the centralized (external) AND centralized-controller
captive portal server resources.
•
hosting-vlan-interface – Optional. Configures the VLAN where the client can reach the wireless
controller (server). This option is available only for the centralized-controller mode.
•
<0-4096> – Specify the VLAN number (0 implies the controller is available on the client’s VLAN).
self Selects the captive portal server as the same device supporting the WLAN (the captive portal and the WLAN
are configured on the same device). Select this option to maintain the captive portal configuration (Web
pages) internally. This is the default setting.
no Resets or disables captive portal host and mode settings