Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 980)

Brocade Mobility RFS Controller CLI Reference Guide 969
53-1003098-01
13
next-server [||]
Example
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#next-server
172.16.10.24
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#show context
static-binding client-identifier test
ip-address 172.16.10.9
client-name RFID
domain-name documentation
netbios-node-type b-node
bootfile test.txt
default-router 172.16.10.8 172.16.10.9
dns-server 172.16.10.7
netbios-name-server 172.16.10.23
next-server 172.16.10.24
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#
Related Commands:
no
static-binding-mode commands
Negates or reverts static binding settings for the selected DHCP server policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [bootfile|client-name|default-router|dns-server|domain-name|ip-address|
netbios-name-server|netbios-node-type|next-server|option|respond-via-unicast|
static-route]
no option
no static-route
Parameters
Configures the next server’s (the first server in the boot process) IP address
Configures a host alias, mapped to the next server’s IP address
•
– Specify the host alias name. It should be existing and configured.
A network host alias maps a name to a single network host. For example, ‘alias host $HOST 1.1.1.100’.
In this example the host alias is ‘$HOST’ and it maps to a single host ‘1.1.1.100’. For more information,
see
alias .
no Resets values or disables DHCP pool static binding settings