Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1258)

1250 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
25
Parameters
match incoming-interface [|pppoe1|vlan <1-4094>|wwan1]
match ip dscp <0-63>
match ip-access-list
match wireless-client-role
match wlan
Example
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#match
incoming-interface pppoe1
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#show context
route-map 1
match incoming-interface pppoe1
default-next-hop wwan1
mark ip dscp 7
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#
Related Commands:
next-hop
route-map-mode
Sets the next hop for packets satisfying match criteria
This command allows you to configure the primary and secondary hop priority requests.
Define the primary and secondary hop settings. When defined, the primary hop resource is used
with no additional considerations when ever it is available.
Supported in the following platforms:
incoming-interface Sets the incoming SVI match clause. Specify an interface name.
Specifies the layer 3 interface name (route interface)
pppoe1 Specifies the PPP over Ethernet interface
vlan <1-4094> Specifies the VLAN interface. Specify a VLAN ID from 1 - 4094.
wwan1 Specifies the WAN interface name
ip dscp <0-63> Sets the DSCP match clause. Specify a value from 0 - 63. The defined DSCP value is used as a matching
clause for this route map.
ip-access-list
Sets the match clause using a pre-configured IP access list. Specify a pre-configured IP access list name.
wireless-client-role
Sets the wireless client role match clause. Specify a pre-configured role policy and a
pre-configured role within it.
wlan Sets the incoming WLAN match clause. Specify a WLAN name.
no Disables match clause settings for this route map