Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 71)

Brocade Mobility RFS Controller CLI Reference Guide 53
53-1003098-01
2
NOTE
For more information on the L2TPv3 tunnel configuration mode and commands, see Chapter 23,
L2TPV3-POLICY .
logging
User Exec Commands
Modifies message logging settings
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
logging monitor
{<0-7>|alerts|critical|debugging|emergencies|errors|informational|
notifications|warnings}
Parameters
logging monitor
{<0-7>|alerts|critical|debugging|emergencies|errors|informational|
notifications|warnings}
Example
rfs4000-229D58>logging monitor warnings
rfs4000-229D58>show logging
Logging module: enabled
Aggregation time: disabled
Console logging: level warnings
Monitor logging: disabled
Buffered logging: level warnings
Syslog logging: level warnings
Facility: local7
monitor Sets the terminal lines logging levels. The logging severity levels can be set from 0 - 7. The system configures
default settings, if no logging severity level is specified.
•
<0-7> – Optional. Specify the logging severity level from 0-7. The various levels and their implications are
as follows:
•
alerts – Optional. Immediate action needed (severity=1)
•
critical – Optional. Critical conditions (severity=2)
•
debugging – Optional. Debugging messages (severity=7)
•
emergencies – Optional. System is unusable (severity=0)
•
errors – Optional. Error conditions (severity=3)
•
informational – Optional. Informational messages (severity=6)
•
notifications – Optional. Normal but significant conditions (severity=5)
•
warnings – Optional. Warning conditions (severity=4)