Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 664)

Brocade Mobility RFS Controller CLI Reference Guide 651
53-1003098-01
7
Example
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#peer
1
ip 192.168.13.6
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show
co
ntext
gre tunnel testGRETunnel
peer 1 ip 192.168.13.6
native tagged
dscp 20
failover interval 200 retry 5
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#
Related Commands:
tunneled-vlan
gre-config-instance
Defines the VLAN that connected clients use to route GRE tunneled traffic within their respective
WLANs
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
tunneled-vlan
Parameters
tunneled-vlan
Example
rfs4000-229D58(config-device
00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#tunneled-vlan 10
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show
context
gre tunnel testGRETunnel
peer 1 ip 192.168.13.6
native vlan 1
tunneled-vlan 1,10
native tagged
no Removes the GRE tunnel settings based on the parameters passed
tunneled-vlan
Specifies the VLANs associated with this GRE tunnel
•
– Specify the VLAN IDs. Specify a comma-separated list of IDs, to specify multiple VLANs.
For example, 1,10,12,16-20