Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 293)

Brocade Mobility RFS Controller CLI Reference Guide 277
53-1003098-01
4
spanning-tree Spanning tree
tunnel-controller Tunnel Controller group this
controller belongs to
use Set setting to use
vrrp VRRP configuration
wep-shared-key-auth Enable support for 802.11 WEP
shared key authentication
clrscr Clears the display screen
commit Commit all changes made in this
session
do Run commands from Exec mode
end End current mode and change to EXEC
mode
exit End current mode and down to
previous mode
help Description of the interactive help
system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to
memory or terminal
nx4500-5CFA2B(config-profile-test)#
NOTE
For more information on profiles and how to configure profiles, see Chapter 7, PROFILES .
Related Commands:
radio-qos-policy
Global Configuration Commands
Configures a radio quality-of-service (QoS) policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
radio-qos-policy
Parameters
radio-qos-policy
no Removes a profile and its associated configurations
Specify the radio QoS policy name. If the policy does not exist, it is created.