Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 272)

256 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
meshpoint [|containing ]
Parameters
meshpoint [|containing ]
Example
rfs7000-37FABE(config)#meshpoint TestMeshpoint
rfs7000-37FABE(config-meshpoint-TestMeshpoint)#?
Mesh Point Mode commands:
allowed-vlans Set the allowed VLANs
beacon-format The beacon format of this meshpoint
control-vlan VLAN for meshpoint control traffic
data-rates Specify the 802.11 rates to be supported on this meshpoint
description Configure a description of the usage of this meshpoint
meshid Configure the Service Set Identifier for this meshpoint
neighbor Configure neighbor specific parameters
no Negate a command or set its defaults
root Set this meshpoint as root
security-mode The security mode of this meshpoint
shutdown Shutdown this meshpoint
use Set setting to use
wpa2 Modify ccmp wpa2 related parameters
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-meshpoint-TestMeshpoint)#
Related Commands:
Specify the meshpoint name. If the meshpoint does not exist, it is created.
containing Selects existing meshpoints containing the sub-string in their names
no Removes an existing meshpoint