User-role – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1103
Brocade Mobility RFS Controller CLI Reference Guide
1095
53-1003098-01
19
The following example shows the role policy ‘test’ setting after the ‘no’
commands are executed:
rfs7000-37FABE(config-role-policy-test)#show context
role-policy test
default-role use ip-access-list in test precedence 1
ldap-query self
rfs7000-37FABE(config-role-policy-test)#
Related Commands:
user-role
This command creates a user-defined role. Each user-defined role has a set of Active Directory
attributes. Each attribute is matched against the information returned by the LDAP server, until a
complete match of role is found.
The following table summarizes user role configuration commands.
user-role
Creates a user-defined role. Each role consists of a set of filters and action. The filters are match
criteria used to filter wireless clients. And the action defines the action taken when a client
matches the specified filters.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
user-role
Assigns a default role to a wireless client
Configures the LDAP deadperiod interval
Enables LDAP service on a role policy
Configures the LDAP server settings
Configures the LDAP server query timeout
Creates a role and associates it to the newly created role policy
Creates a new user role and enters its configuration mode
Summarizes user role configuration mode commands