Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 145)

128 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
The no commands have their own set of parameters that can be reset. These parameters depend
on the context in which the command is being used.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
[adoption|captive-portal|crypto|debug|logging|mac-user-db|page|raid|service|
terminal|upgrade|virtual-machine|wireless]
no adoption {on }
no captive-portal client [captive-portal |mac ]
{on }
no crypto pki [server|trustpoint]
no crypto pki [server|trustpoint] {del-key {on
}|
on }
no logging monitor
no page
no service [block-adopter-config-update|locator|ssm|wireless]
no service block-adopter-config-update
no service locator {on }
no service [ssm|wireless] trace pattern {|on }
no terminal [length|width]
no upgrade {on }
no wireless client [all|]
no wireless client all {filter|on}
no wireless client all {filter [wlan ]}
no wireless client all {on } {filter [wlan
]}
no wireless client mac {on }
Parameters
no adoption {on }
no adoption
{on
>} Resets adoption status of a specified device or all devices in a specified RF Domain
•
– Optional. Enter the name of the AP, wireless controller, service
platform, or RF Domain. This command resets the adoption status of the specified device and all
devices adopted by it.