Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 984)

Brocade Mobility RFS Controller CLI Reference Guide 973
53-1003098-01
13
Related Commands:
static-route
static-binding-mode commands
Adds static routes to the static binding configuration
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
static-route
Parameters
static-route
Example
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-1)#static-route
10.0.0.0/10 157.235.208.235
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#show context
static-binding client-identifier test
client-name RFID
domain-name documentation
netbios-node-type b-node
netbios-name-server 172.16.10.23
next-server 172.16.10.24
option option1 172.16.10.10
respond-via-unicast
static-route 10.0.0.0/10 157.235.208.235
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#
Related Commands:
no
dhcp-server-policy
Negates a command or sets its default. When used in the DHCP server configuration context, the
‘no’ command resets or reverts the DHCP server policy settings.
no Resets values or disables DHCP pool static binding settings
Sets the subnet for which the static route is configured
Specify the gateway’s IP address
no Resets values or disables DHCP pool static route settings