Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1321)

Brocade Mobility RFS Controller CLI Reference Guide 1313
53-1003098-01
28
Advertises the IP address type used in this hotspot. This information is returned in response to
ANQP queries.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
ip-address-type [ipv4|ipv6]
ip-address-type ipv4 [double-nat|not-available|port-restricted|
port-restricted-double-nat|port-restricted-single-nat|public|single-nat|unkno
wn]
ip-address-type ipv6 [available|not-available|unknown]
Parameters
ip-address-type ipv4 [double-nat|not-available|port-restricted|
port-restricted-double-nat|port-restricted-single-nat|public|single-nat|unkno
wn]
ip-address-type ipv6 [available|not-available|unknown]
Example
rfs4000-229D58(config-passpoint-policy-test)#ip-address-type ipv6 available
rfs4000-229D58(config-passpoint-policy-test)#
rfs4000-229D58(config-passpoint-policy-test)#show context
hotspot2-policy test
access-network-type chargeable-public
connection-capability ip-protocol 2 port 10 closed
ip-address-type ipv4 Configures the as IPv4 address type availability information
double-nat Specifies double NATed private IPv4 address is available
not-available Specifies IPv4 address is not available
port-restricted Specifies port-restricted IPV4 address is available
port-restricted-double-nat Specifies port-restricted IPv4 address and double NATed IPv4 address is available
port-restricted-single-nat Specifies port-restricted IPv4 address and single NATed IPv4 address is available
public Specifies public IPv4 address is available
single-nat Specifies single NATed IPv4 address is available
unknown Specifies no information configured regarding the IPv4 address availability
ip-address-type ipv6 Configures the IPv6 address type availability information
available Specifies IPv6 address is available
not-available Specifies IPv6 address is not available
unknown Specifies no information configured regarding the IPv6 address availability