Localid, Remoteid – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 617
604
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
localid
crypto-ikev1/ikev2-peer commands
Sets a IKEv1/IKEv2 peer’s local identity credentials
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
localid [address|dn|email|fqdn|string]
localid [address
The following command is specific to the IKEv2 peer configuration:
localid autogen-uniqueid
Parameters
localid [address
localid autogen-uniqueid
Example
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#localid email
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#show context
crypto ikev1 peer peer1
ip address 172.16.10.12
localid email [email protected]
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#
remoteid
crypto-ikev1/ikev2-peer commands
Configures a IKEv1/IKEV2 peer’s remote identity credentials
Supported in the following platforms:
address
Configures the peer’s IP address. The IP address is used as local identity.
dn
Configures the peer’s distinguished name. (for example, "C=us ST=
OU=
email
Configures the peer’s e-mail address. The maximum length is 128 characters.
fqdn
Configures the peer’s FQDN. The maximum length is 128 characters.
string
Configures the peer’s identity string. The maximum length is 128 characters.
autogen-uniqueid
Prefixes the autogen-uniqueid of the device to the string provided here. The device’s autogen-uniqueid should
be existing and configured. For more information on autogen-uniqueid, see
.
•