Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1290)

1282 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
Parameters
use meshpoint-qos-policy
Example
rfs7000-37FABE(config-meshpoint-test)#use meshpoint-qos-policy test
rfs7000-37FABE(config-meshpoint-test)#show context
meshpoint test
description "This is an example of a meshpoint description"
meshid TestingMeshPoint
shutdown
beacon-format mesh-point
control-vlan 1
allowed-vlans 1,10-16,18-23
neighbor inactivity-timeout 300
data-rates 2.4GHz bgn
data-rates 5GHz an
security-mode psk
root
use meshpoint-qos-policy test
rfs7000-37FABE(config-meshpoint-test)#
Related Commands:
wpa2
meshpoint-config-instance
This command sets the pre-shared keys and key rotation duration
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
wpa2 [psk|key-rotation]
wpa2 key-rotation [broadcast|unicast] <30-86400>
wpa2 psk [0 |2 |]
Parameters
use meshpoint-qos-poicy Configures this meshpoint to use a predefined meshpoint QoS policy
Defines the meshpoint QoS policy to use with this meshpoint
no Removes the meshpoint QoS policy associated with this meshpoint
meshpoint-qos-policy-config-instanc
e Creates and configures a meshpoint QoS policy