Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1110)

1102 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
19
Related Commands:
captive-portal
user-role commands
Configures a captive portal based filter for this user-defined role. A captive portal is a guest access
policy that provides temporary and restrictive access to the wireless network. When applied to a
WLAN, a captive portal policy ensures secure guest access.
This command defines user-defined role filters based on a wireless client’s state of authentication.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
captive-portal authentication-state [any|post-login|pre-login]
Parameters
captive-portal authentication-state [any|post-login|pre-login]
Example
rfs7000-37FABE(config-role-policy-test-user-role-testing)#captive-portal
authentication-state pre-login
rfs7000-37FABE(config-role-policy-test-user-role-testing)#show context
user-role testing precedence 10
authentication-type eq kerberos
br-location contains office
captive-portal authentication-state pre-login
rfs7000-37FABE(config-role-policy-test-user-role-testing)#
Related Commands:
no Removes the authentication type filter configured for this user-defined role
authentication-state Defines the authentication state of a client connecting to a captive portal
any Specifies any authentication state (authenticated and pending authentication). This is the default setting.
This option makes no distinction on whether authentication is conducted before or after the wireless client
has logged in.
post-login Specifies authentication is completed successfully
This option requires the wireless client to share authentication credentials after logging into the managed
network.
pre-login Specifies authentication is pending
This option enables captive portal client authentication before the client is logged into the controller
no Removes the captive portal based role filter settings