Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 37)

Brocade Mobility RFS Controller CLI Reference Guide 19
53-1003098-01
2
-----------------------------------------------------------------------------
---
CONTROLLER STATUS MESSAGE
-----------------------------------------------------------------------------
---
00-23-68-22-9D-58 Success Cancelled upgrade of 1 APs
-----------------------------------------------------------------------------
---
rfs4000-229D58>
change-passwd
User Exec Commands
Changes the password of a logged user. When this command is executed without any parameters,
the password can be changed interactively.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
change-passwd {}
Parameters
change-passwd {}
Usage Guidelines:
A password must be from 1 - 64 characters.
Example
rfs7000-37FABE>change-passwd
Enter old password:
Enter new password:
Password for user 'admin' changed successfully
Please write this password change to memory(write memory) to be persistent.
rfs7000-37FABE#write memory
OK
rfs7000-37FABE>
clear
User Exec Commands
Optional. Specify the password to be changed.
Specify the new password.
NOTE: The password can also be changed interactively. To do so, press [Enter] after the command.