Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 635)

622 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
The following table lists the IPSec manual VPN tunnel configuration commands:
local-endpoint-ip
crypto-map-ipsec-manual-instance
Uses the configured IP as local tunnel endpoint address, instead of the interface IP (Advanced
Configuration)
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
local-endpoint-ip
Parameters
local-endpoint-ip
Example
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#local-endpoin
t-ip 172.16.10.3
mode
crypto-map-ipsec-manual-instance
Sets the crypto map tunnel mode
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Command Description Reference
local-endpoint-ip Uses the configured IP as local tunnel endpoint address, instead of the interface IP (Advanced
Configuration) page 7-622
mode Sets the tunnel mode page 622
peer Sets the peer device’s IP address page 7-623
security-association Defines the lifetime (in kilobytes and/or seconds) of IPSec SAs created by a crypto map page 7-624
session-key Defines encryption and authentication keys for a crypto map page 7-624
use Uses the configured IP access list page 7-626
no Negates a command or sets its default page 7-626
local-endpoint-ip Uses the configured IP as local tunnel’s endpoint address
•
– Specify the IP address. The specified IP address must be available on the interface.