Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1204)

1196 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
23
reconnect-interval 100
reconnect-attempts 50
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
r(config-l2tpv3-policy-L2TPV3Policy1)#no hello-interval
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#no reconnect-attempts
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#no reconnect-interval
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#no retry-attempts
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#no retry-interval
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#no cookie-size
The following example shows the l2tpv3 policy ‘L2TPV3Policy1’ settings after
the ‘no’ commands are executed:
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
reconnect-attempts
l2tpv3-policy-commands
Configures the maximum number of attempts made to re-establish a tunnel connection
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
reconnect-attempts <0-8>
Parameters
cookie-size Configures the cookie-field size present in each L2TPv3 data packet
failover-delay Configures the L2TPv3 tunnel failover delay in seconds
force-12-path-recovery Enables the forced detection of servers and gateways behind the L2TPv3 tunnel
hello-interval Configures the interval for L2TPv3 “Hello” keep-alive messages
reconnect-attempts Configures the maximum number of attempts made to reestablish a tunnel connection
reconnect-interval Configures the interval, in seconds, between successive attempts to re-establish a tunnel connection
retry-attempts Configures the maximum number of retransmissions for signalling messages from 1 - 10
retry-interval Configures the interval, in seconds, before initiating a retransmission of any L2TPv3 signalling message
rx-window-size Configures the number of packets received without sending an acknowledgment
tx-window-size Configures the number of packets transmitted without receiving an acknowledgment