Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 78)

60 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
2
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
ping {count <1-10000>|dont-fragment {count|size}|size <1-64000>}
Parameters
ping {count <1-10000>|dont-fragment {count|size}|size <1-64000>}
Example
rfs7000-37FABE>ping 172.16.10.4 count 6
PING 172.16.10.4 (172.16.10.4): 100 data bytes
108 bytes from 172.16.10.4: seq=0 ttl=64 time=0.851 ms
108 bytes from 172.16.10.4: seq=1 ttl=64 time=0.430 ms
108 bytes from 172.16.10.4: seq=2 ttl=64 time=0.509 ms
108 bytes from 172.16.10.4: seq=3 ttl=64 time=0.507 ms
108 bytes from 172.16.10.4: seq=4 ttl=64 time=0.407 ms
108 bytes from 172.16.10.4: seq=5 ttl=64 time=0.402 ms
--- 172.16.10.4 ping statistics ---
6 packets transmitted, 6 packets received, 0% packet loss
round-trip min/avg/max = 0.402/0.517/0.851 ms
rfs7000-37FABE>
ssh
User Exec Commands
Opens a Secure Shell (SSH) connection between two network devices
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Specify the destination IP address or hostname. When entered without any parameters, this command
prompts for an IP address or a hostname.
count <1-10000> Optional. Sets the pings to the specified destination
•
<1-10000> – Specify a value from 1 - 10000. The default is 5.
dont-fragment
{count|size} Optional. Sets the don’t fragment bit in the ping packet. Packets with the dont-fragment bit specified are not
fragmented. When a packet, with the dont-fragment bit specified, exceeds the specified maximum
transmission unit (MTU) value, an error message is sent from the device trying to fragment it.
•
count <1-10000> – Optional. Sets the pings to the specified destination from 1 - 10000. The default is 5.
•
size – <1-64000> – Optional. Sets the size of ping payload size from 1 - 64000 bytes. The default is 100
bytes.
size <1-64000> Optional. Sets the ping payload size in bytes
•
<1-64000> – Specify the ping payload size from 1 - 64000. The default is 100 bytes.