Attribute – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 849
836
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
8
Example
rfs7000-37FABE(config-aaa-policy-test)#accounting interim interval 65
rfs7000-37FABE(config-aaa-policy-test)#accounting server 2 host 172.16.10.10
secret example port 1
rfs7000-37FABE(config-aaa-policy-test)#accounting server 2 timeout 2 attempts
2
rfs7000-37FABE(config-aaa-policy-test)#accounting type start-stop
rfs7000-37FABE(config-aaa-policy-test)#accounting server preference
auth-server-number
rfs7000-37FABE(config-aaa-policy-test)#show context
aaa-policy test
accounting server 2 host 172.16.10.10 secret 0 example port 1
accounting server 2 timeout 2 attempts 2
accounting interim interval 65
accounting server preference auth-server-number
rfs7000-37FABE(config-aaa-policy-test)#
Related Commands:
attribute
Configures RADIUS Framed-MTU attribute used in access and accounting requests. The
Framed-MTU attribute reduces the Extensible Authentication Protocol (EAP) packet size of the
RADIUS server. This command is useful in networks where routers and firewalls do not perform
fragmentation.
To ensure network security, some firewall software drop UDP fragments from RADIUS server EAP
packets. Consequently, the packets are large. Using Framed MTU reduces the packet size. EAP
authentication uses Framed MTU to notify the RADIUS server about the Maximum Transmission
Unit (MTU) negotiation with the client. The RADIUS server communications with the client do not
include EAP messages that cannot be delivered over the network.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
attribute
[acct-delay-time|acct-multi-session-id|chargeable-user-identity|cisco-vsa|
framed-mtu|location-information|nas-ipv6-address|operator-name|service-type]
attribute acct-delay-time
attribute acct-multi-session-id
Removes or resets accounting server parameters