Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 506)

492 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
rfs7000-37FABE(config)#show mint route on rfs7000-37FABE
Destination : Next-Hop(s)
70.37.FA.BE : 70.37.FA.BE via self
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show mint known-adopters on rfs7000-37FABE
70.37.FA.BE
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show mint config
Base priority 180
DIS priority 180
Control priority 180
UDP/IP Mint encapsulation port 24576
Global Mint MTU 1500
rfs7000-37FABE(config)#
ntp
show commands
Displays Network Time Protocol (NTP) information. NTP enables clock synchronization within a
network.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show ntp [associations|status]
show ntp [associations {detail|on}|status {on }]
Parameters
show ntp [associations {detail|on}|status {on }]
Example
rfs7000-37FABE>show ntp associations
address ref clock st when poll reach delay offset disp
* master (synced), # master (unsynced), + selected, - candidate, ~ configured
rfs7000-37FABE>
ntp associations
{detail|on} Displays existing NTP associations
•
detail – Optional. Displays detailed NTP associations
•
on – Optional. Displays NTP associations on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.
ntp status
{on } Displays NTP association status
•
on – Optional. Displays NTP association status on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.