Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1203
Brocade Mobility RFS Controller CLI Reference Guide
1195
53-1003098-01
23
no
Negates or reverts L2TPv3 policy settings to default
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
no [cookie-size|failover-delay|force-12-path-recovery|hello-interval|
reconnect-attempts|reconnect-interval|retry-attempts|retry-interval|rx-window
-size|
tx-window-size]
Parameters
no
[cookie-size|failover-delay|force-12-path-recovery|hello-interval|reconnect-a
ttempts|reconnect-interval|retry-attempts|retry-interval|rx-window-size|tx-wi
ndow-size]
Example
The following example shows the l2tpv3 policy ‘L2TPV3Policy1’ settings before
the ‘no’ commands are executed:
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
hello-interval 200
retry-attempts 10
retry-interval 30
cookie-size 8
no cookie-size
Resets the cookie-field size to default (0 - no cookie field present in each L2TPv3 data packet)
no fail
-
over-delay
Resets the failover interval to its default (5 seconds)
no force-12-path-recovery
Disables the forced detection of servers and gateways behind the L2TPv3 tunnel
no hello-interval
Resets the “Hello” keep-alive message interval to default (60 seconds)
no reconnect-attempts
Resets the maximum number of reconnect attempts to default (0 - configures infinite attempts)
no reconnect-interval
Resets the interval between successive attempts to re-establish a tunnel connection to default (120
seconds)
no retry-attempts
Resets the maximum number of retransmissions for signalling messages to default (5 attempts)
no retry-interval
Resets the interval before initiating a retransmission of a L2TPv3 signalling message to default (5 seconds)
no rx-window-size
Resets the number of packets received without sending an acknowledgment to default
(10 packets)
no tx-window-size
Resets the number of packets transmitted without receiving an acknowledgment to default
(10 packets)