Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1213)

Brocade Mobility RFS Controller CLI Reference Guide 1205
53-1003098-01
23
Related Commands:
mtu
l2tpv3-tunnel-commands
Configures the Maximum Transmission Unit (MTU) size for this tunnel. This value determines the
packet size transmitted over this tunnel.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
mtu <128-1460>
Parameters
mtu <128-1460>
Example
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#mtu 1280
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#show
context
l2tpv3 tunnel Tunnel1
local-ip-address 172.16.10.2
mtu 1280
hostname TunnelHost1
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
Related Commands:
no
l2tpv3-tunnel-commands
Negates or reverts a L2TPv3 tunnel settings to default
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
no Resets the tunnel’s local IP address and re-establishes the tunnel
mtu <128-1460> Configures the MTU size for this tunnel. Specify a value from 128 - 1460 bytes (default is 1460 bytes).
no Resets the MTU size for this tunnel to default (1460 bytes)