Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 690)

Brocade Mobility RFS Controller CLI Reference Guide 677
53-1003098-01
7
crypto map
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#crypto map map1
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#show context
interface vlan8
crypto map map1
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
Related Commands:
description
interface-config-vlan-instance
Defines a VLAN interface description. Use this command to provide additional information about
the VLAN.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
description
Parameters
description
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#description “This
VLAN interface is configured for the Sales Team”
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#show context
interface vlan8
description This\ VLAN\ interface\ is\ configured\ for\ the\ Sales\ Team
crypto map map1
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
Related Commands:
map
Attaches a crypto map to the selected VLAN interface. The crypto map should be existing and
configured.
•
– Specify the crypto map name.
no Disables or reverts interface VLAN settings to their default
description Configures a description for this VLAN interface
no Removes the VLAN interface description