Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 619)

606 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use ikev1-policy
use ikev2-policy
Parameters
use ikev1-policy
use ikev2-policy
Example
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#use
ikev1-policy test-ikev1policy
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#show context
crypto ikev1 peer peer1
ip address 172.16.10.12
remoteid dn SanJose
localid email [email protected]
use ikev1-policy test-ikev1policy
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#use
ikev2-policy test-ikev2policy
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#show context
crypto ikev2 peer peer1
remoteid address 157.235.209.63
use ikev2-policy test-ikev2policy
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#
no
crypto-ikev1/ikev2-peer commands
Removes or reverts IKEv1/IKEv2 peer settings
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [authentication|ip|localid|remoteid|use]
use ikev1-policy
Specify the IKEv1 policy name.
The local IKE policy and the peer IKE policy must have matching group settings for successful negotiations.
use ikev2-policy
Specify the IKEv2 policy name.
The local IKE policy and the peer IKE policy must have matching group settings for successful negotiations.