Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1089)

Brocade Mobility RFS Controller CLI Reference Guide 1081
53-1003098-01
18
• An administrator-defined interval has elapsed since the first frame (of a set of frames to be
aggregated) was received
• An administrator-defined interval has elapsed since the last frame (not necessarily the final
frame) of a set of frames to be aggregated was received
With this enhancement, an aggregation delay is set uniquely for each traffic class. For example,
voice traffic might not be aggregated, but sent immediately. Whereas, background data traffic is
set a delay for aggregating frames, and these aggregated frames are sent.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
smart-aggregation {delay|max-mesh-hops|min-aggregation-limit}
smart-aggregation {delay
[background|best-effort|streaming-video|video-conferencing|
voice] <0-1000>}
smart-aggregation {max-mesh-hops <1-10>}
smart-aggregation {min-aggregation-limit <0-64>}
Parameters
smart-aggregation {delay
[background|best-effort|streaming-video|video-conferencing|
voice] <0-1000>}
smart-aggregation {max-mesh-hops <1-10>}
delay Optional. Configures the maximum delay parameter for each traffic type
This is the maximum delay, in milliseconds, in the transmission of the first frame received.
background Configures the maximum delay parameter, in milliseconds, for background traffic (250 msec)
best-effort Configures the maximum delay parameter, in milliseconds, for best effort traffic (150 msec)
streaming-video Configures the maximum delay parameter, in milliseconds, for streaming video traffic
(150 msec)
video-conferencing Configures the maximum delay parameter, in milliseconds, for video conference traffic
(40 msec)
voice Configures the maximum delay parameter, in milliseconds, for voice traffic (0 msec)
<0-1000> This parameter is common to all of the above traffic types.
•
<0-1000> – Specify a value from 0 - 1000 msec.
max-mesh-hops <1-10> Optional. Sets the maximum number of expected hops to the destination within a mesh
•
<1-10> – Specify a value from 1 - 10. The default is 3 hops.