Restrict-access – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1036
Brocade Mobility RFS Controller CLI Reference Guide
1027
53-1003098-01
16
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
privilege-mode-password [1
Parameters
privilege-mode-password [1
Example
rfs7000-37FABE(config-management-policy-test)#privilege-mode-password
testing@1234
rfs7000-37FABE(config-management-policy-test)#
rfs7000-37FABE(config-management-policy-test)#show context
management-policy test
http server
no ssh
privilege-mode-password 1
2e9f038ac2ed27f919ed5a4dceb3d30e32f356f2ceff6fbf26a153d0339c
734f
rfs7000-37FABE(config-management-policy-test)#
Related Commands:
restrict-access
Restricts management access to a set of hosts or subnets
Restricting remote access to a controller or service platform ensures only trusted hosts can
communicate with enabled management services. This ensures only trusted hosts can perform
management tasks and provide protection from brute force attacks from hosts attempting to break
into the controller or service platform managed network.
Administrators can permit management connections to be established on any IP interface on the
controller or service platform (including IP interfaces used to provide captive portal guest access).
Administrators can restrict management access by limiting access to a specific host (IP address),
subnet, or ACL on the controller or service platform.
Supported in the following platforms:
1
Configures an encrypted password. Use this option when copy pasting the password from another device.
•
Configures a clear text password
•
Removes the configured CLI privilege mode access password